Wiped Film Evaporators
Vobis Wiped Film Evaporators
Vobis manufactures Wiped Film Evaporator systems (also called agitated Thin Film Evaporators) for high viscosity (to hundreds of thousands of cP), heat sensitive, foaming or fouling applications, for which either high heat transfer or high mass transfer coefficients are required. Our systems offer minimal process fluid hold up, short residence time plug flow evaporation under vacuum conditions.
Our WFE evaporator systems can range up to 100m2 of heat transfer surface area.
How Our Wiped Film Evaporators Work
Feed material is tangentially distributed onto the interior wall of the evaporator, and the wiping or fixed clearance blades smear this liquid against the heated surface in a rapidly renewed thin film with heat on one side and the vacuum conditions on the other side of the film. The residence time of this material inside the wiped film evaporator is a few seconds before the concentrated bottoms exit the evaporator. Evaporated volatile components exit the wiped film evaporator and are condensed in a separate chamber. (If micron vacuum levels are required to reduce heating conditions further, please see our molecular distillation section for more information regarding this alternative.)
Advantages of Our Wiped Film Evaporators
Vobis Wiped Film evaporators induce a mechanically agitated thin (wiped) film with a high surface renewal rate against the interior heat transfer surface while the evaporator is operating under vacuum, so that the product sees primarily the equilibrium conditions inside the evaporator.
The separation of lights from heavies in our Wiped Film evaporation systems is usually accomplished in a single pass in a plug flow manner to minimize product heat exposure.
Either a great deal of volatile components can be evaporated, or the rapid surface renewal and large delta T provided by the material being wiped across the heat transfer surface can be used to deliver high mass transfer rates to reduce volatile components to low PPM levels without degrading heat sensitive actives.
Vobis Wiped Film evaporation systems offer a unique means to process heat sensitive materials which can also be viscous and/or fouling. These systems are constructed of various metallurgies including a broad range of SS alloys, Hastelloy, duplex steels or titanium and typically include the primary peripherals such as vacuum system, pumps, piping and controls.
Typical Applications for Our Wiped Film Evaporators
Lecithin drying and glycerin recovery and purification
Solvent stripping from foods
Concentration of sugar solutions to 99.5%
Recycling of solvents from greases and oils
Hemp distillation
Removal of solvents and monomers from polymers, either natural or synthetic
Reaction and removal of condensates from polyesters or capralactam from nylon 6
Purification of essential oils
Concentration of enzymes, fruit and vegetable purees, proteins, vitamins, and biological solutions
Botanicals
Further Considerations
High viscosity, tens of thousands of cP
Heat sensitive products or actives
Foaming, which are normally difficult to separate
Fouling, which the high surface renewal rate helps to resolve
Also note:
Allen Bradley or Siemens PLC control systems are typically implemented to accurately and reproducibly control our Wiped Film evaporation systems.
Skid mounting where appropriate allows easy installation as well as ready access to all piping, control elements, and process vessels.
Free Consultation
Contact us to discuss how our Vobis Wiped Film Evaporation Systems can accomplish the efficient evaporation of your particular product. Call us for a FREE CONSULTATION at 610-438-1544 or fill out the Contact Form below, and we will contact you within 24 hours.
Contact
Feel free to contact us with any requests.
Email
solutionsvobis@gmail.com
Phone
(610)438-1544